Digital display push-pull gauge error occurs how to do it, many digital push-pull gauge users in the use of digital push-pull force meter will encounter such a situation today, cast digital display push-pull gauge Xiaobian to teach everyone how to solve The reason for the error in digital force gauges is that, first of all, the reasons for the use of errors in the digital force gauge should be analyzed first. The main reasons for this are: Digital force gauge data chart More about the exciting content of the digital push-pull force meter: http://. . Com/zhyq-ParentList-266713/ This article is recommended by: Torque Tester Torque Wrench Tester Brass Hose Fittings,Hose Pipe Connector,Brass Hose Nipple,Brass Pipe Hose Nipple Jiangmen Xinhui Yilin Co.,Ltd , https://www.ylseiko.com
One, garbled problems. When the used weight exceeds 20% of the digital push-pull measuring range or the load of the machine exceeds 20% of the range, the clear key cannot be cleared. In this case, a lighter fixture or the applied load must be used again. Cleared.
Press and hold this key for 4 seconds, the stored test data can be completely cleared (some conditions may not be cleared, then turn off and then restart this function to clear all memory data).
Second, when the internal parts of the aging or damage, we should learn to start from the circuit part of the initial diagnosis and testing, to avoid the circuit due to charging or calibration problems lead to short circuit problems.
The details of the circuit part include the battery, circuit board, sensor connection line detection, etc. At this time, we need the universal meter to perform the auxiliary work. The use of the universal meter and the operation and learning are also indispensable. To become a maintenance expert, we must understand Part of the circuit knowledge, from the circuit ink circuit step by step, is our solution to the problem faster and more stable approach.
Three: When the test pole is not connected to any test head, the load under test cannot be directly applied to the test rod end.
Four: Please do not use damaged or bent deformation of the test head, so that the error is inevitable.
Five: Please do not use the load that often exceeds the maximum test load, otherwise the elasticity of the load detection mechanism will gradually deteriorate, resulting in the detected load value can not reach the required accuracy level.
Six: Should pay attention to when using, first check whether the battery voltage is normal before use, if it is under voltage, please charge in time, otherwise the measurement will show deviation.
Seven: There is no regular maintenance and repairs:
1: Electricity supplies energy, so if it is not used for a long time, it should be charged periodically.
2: Put into the box and put it to room temperature after each use
How to do if the digital push-pull gauge shows an error?