The utility model discloses a Kitchen Shower head that is convenient to switch the water outlet mode, has a compact structure, and is easy to use and a kitchen faucet using the kitchen shower head. The shower head includes a shower body and a shower head provided with a spray water outlet and a V-shaped water outlet. , The shower head is provided with a water separator, and the water separator is provided with an annular flow channel and an inner flow channel respectively connected to the spray water outlet body and the V-shaped water outlet body, and the lower end of the outer wall of the water separator is upwardly circular A plurality of water inlet holes connected to the annular flow channel are provided, and a first sealing ring is provided on the lower side of the water inlet hole; the water outlet end of the shower body is connected with a converter, and the converter is provided with a communicating In the water diversion cavity at the water outlet end of the shower body, the lower end of the water diversion device is installed in the water diversion cavity and can move up and down, and the upper end of the inner wall of the water diversion cavity is provided with a matching first sealing ring Kitchen Pull Shower,Kitchen Pull Shower Head,Stainless Steel Shower Head,Rotating Wash Basin Shower Yuyao Zelin Sanitary Ware Co., Ltd , https://www.zelinshower.com
2, performance: weight 8.7kg, cylinder volume 6.8L, working pressure 30MPa, gas storage 1857L, use time 60min, alarm pressure 4-6MPa, air supply 300L/min.
(B), Bao Bao single bottle air respirator 1, the structure consists of: back care, gas bottles, gas valves, pressure relief valves, masks, pressure gauges, shoulder straps, belts and other components.
2, performance: weight 11.8kg, cylinder volume 9L, working pressure 30MPa, gas storage capacity 2460L, use time 90min, alarm pressure 4-6MPa.
(C), according to double-bottle air respirator 1, structural composition: back care, gas bottles, gas valves, pressure relief valves, masks, pressure gauges, shoulder straps, belts and other components.
2, performance: weight 18kg, cylinder volume 2 x 6.8L, working pressure 30MPa, use time 136min, air supply volume 300L/min, alarm pressure 4-6MPa.
3. Usage: It is mainly used on fires with toxic gases and smoke.
4. How to use: 1 Check the respirator is complete and easy to use, the pressure is not less than 25MPa. 2 Adjust the shoulder straps and belts to ensure comfortable fastening. 3 Fit the air supply valve interface into the mask and rotate it clockwise. The sound of the click is installed. 4 The gas supply valve must be fully opened to use while observing the pressure.
5, note: 1 between the mask and the skin without hair, beard, etc., to ensure that the mask is sealed. 2 The cylinder pressure must not be less than 25MPa. 3 The pressure is expressed to 4-6MPa, and the alarm signal is sent out immediately. 4 The room where the air respirator is stored should be kept at room temperature of about 5-30°C, and the relative humidity should be 40-80%. There should be no corrosive gas in the air. The full-face mask that is not used for a long time should be stored in its natural state. The rubber parts should be coated with talc. Powder to extend the service life.
Brief Analysis of Three Categories of Personal Respirator Air Respirator
(a), according to the single bottle of air respirator 1, structural composition: back care, gas bottles, gas valves, pressure relief valves, masks, pressure gauges, shoulder straps, belts and other components.