Although the door and window decoration is not installed by yourself, it is also necessary to understand some precautions for the decoration of the door and window. It seems that there are many problems to be noticed in the simple decoration of the door and window. Let's take a look at the contents of the door and window decoration. First, the door and window leave too much gap During the renovation, the master of the planing repair left the gap too large, or when it was installed, it did not form a vertical with the ground. The door and window could be removed, and the planing was completed until the fit was completed. If it is difficult to grasp vertically, you can straighten the gasket under the door and window frame. Second, the quality of hardware is poor The hinge of the swing door is not correct, which will cause the water of the frame and the door and window to be neat, and the screws of the fixed door are reinforced, and the inclination of the door and the window cover is adjusted to be neat. Do not screw too tightly and it is not convenient to adjust. If it is tightened once, it will cause the door and window to be too tight or too loose. The upper screw should be kept straight, and it should be nailed halfway and then tightened. Third, the door leaf switch is not smooth Generally, the locking tongue of the door is not installed correctly, and the size of the formation lock is not suitable. The biggest reason is that the locking tongue and the board are not aligned, and the marking is required before installation. Fourth, push the door effort The general reason for the formation is that the upper and lower track grooves are not vertical and are not in the same vertical direction. The track can be first removed, and the upper and lower rails and the center of the track groove are aligned with the vertical ruler. Five, other matters needing attention The overall frame is just too weak, the doors and windows are difficult to switch, and the wind and rain are shaking and see if the following can be solved: 1. The material selected is not suitable and the hardness is not enough. If the material of the aluminum alloy does not meet the requirements. Or the quality is not off. 2. Steel door cover, does not meet the standard, the thickness is above 1.2, this is because the manufacturer installed it, you do not know, and there is no way, so before installation, you must ask clearly. 3. The installation is not standardized enough. 4. The installation wall is not fixed and invalid. Black Lamp,T8 Blb Light,T8 Blb Bulb,T8 Blb Tube Changxing leboom lighting product CO.Ltd. , https://www.leboomuvd.com
Have to understand the door and window decoration precautions