Screw lifter is a common basic lifting and lifting equipment. It can be used for lifting, lower pressing, push-pull and reverse. It is suitable for installation and use in many occasions. For some special occasions, it can also be used for non-standard design processing according to the working conditions. During the installation of the lift, we need to pay attention to the points. Stainless steel sink is a best optimization for the kitchen use with best durability and addorability. Stainless steel sink single is with single bowl on the sink, to provide the kitchen user more room to finish different cleaning jobs at the same time, and make job more organized with stainless steel sink with double . And its different installation ways like undermount, top mount, drop in, and apron front can satisfy your kitchen cabinet design needs. A good stainless steel sink can make your kitchen life more easy and with pleasure! Single Bowl Handmade Sinks,Handmade Sinks,Handmade Stainless Steel Kitchen Sink,Stainless Steel Handmade Sink Guangdong Huayou Hardware Products Co.,Ltd , https://www.gdhuayouhardware.com
Screw lifter is a common basic lifting and lifting equipment. It can be used for lifting, lower pressing, push-pull and reverse. It is suitable for installation and use in many occasions. For some special occasions, it can also be used for non-standard design processing according to the working conditions. During the installation of the lift, we need to pay attention to the points.
Demai drive screw lifts do not load the initial test lifting system. The initial test can be used to increase the load gradually. It is necessary to pay attention to the screw shaft speed and the load carried. For the maximum allowable load of the lift, allow the applied load, allow the screw Radial calibration of the shaft rotation speed and other items, if the data exceeds the product will cause significant damage to the elevator equipment as a whole. Check the temperature rise of any hot spots and gearbox while loading. The surface temperature of the speed reducer should be controlled within the range of -15C ° to 80C when the lift is working, and the surface temperature of the movable nut is also within the appeal range.
The arrangement of the screw lifts should be leveled. The parallel between the lifting system and the guiding machine needs to be carefully confirmed. When it is installed and used in a narrow place, its rotation should be detected. The hand drive is the system that is easy and stable during the complete operation. The screw must be cleaned before commissioning if it is possible to spray grease over the entire stroke.
Check the stability of the limit switch and all the connecting bolts. All the fixing bolts must be retightened after running for a period of time. Under extreme operating conditions, the wear of the nut (worm gear) must be checked at shorter intervals. Mainly check the clearance of the thread, the specific time depends on the power-on time.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Need to pay attention to the screw lift during installation