Fingerprint attendance machine how to change the time? Fingerprint attendance machine how to export data? Fingerprint attendance machine how to set up to use? Fingerprint attendance machines are widely used in day-to-day management of companies. As a personnel or manager, it is very necessary to be familiar with the operation and use of the fingerprint attendance machine, which can greatly improve the work efficiency. This paper mainly introduces the use of the fingerprint attendance machine and explains the basic operation methods. There are two methods for adjusting the time of the fingerprint attendance machine. The specific operations are as follows: 1, the fingerprint attendance machine and computer software connection, connection methods are USB, RS232 or RS485, TCP / IP methods. After the software displays the “Connected Successfully†prompt, click on “Device Management†to enter the device management interface and click on “Synchronize Time on Time Attendance†to adjust the time. 2, in the fingerprint attendance machine interface to operate, press MENU-system settings - time settings, adjust the machine system time, the operation is successful, click OK. If you are exporting the check-in time, how to modify it? The following is the operation to modify the export record time sheet Excel time: Open the Excel form through the office software, you can see the employee's check-in time and frequency, modify the form will prompt the protected file: Can not modify the protected read-only cell on the protected worksheet. View the toolbar, click "Review" and select "Undo Worksheet Protection". Double-click the data you want to modify. The amendment is that the employee's attendance record can be supplemented by the system replacement card. 1, because the fingerprint attendance machine is to use USB cable to download data, so first in the attendance software "equipment maintenance" in the attendance machine and software "communications" set to USB download, and then click Save. 2. Then power on the attendance machine, insert the USB cable into the attendance machine and the USB interface of the computer, select “USB connection method†in the “My Device Listâ€, and then connect the device, wait a few seconds, the device is connected successfully, at the same time The circle of the device name will be colored, and at the same time, the system will prompt successful connection in the lower right corner, and the attendance machine and the computer software will be connected successfully. 3. After successful connection, click "Download Record Data from Device". At this time, the data in the attendance machine will be uploaded to the software through the data cable. At the same time, there are tips for how many records to download. Then click "Attendance Record" to see All attendance record data downloaded. Note: To determine what your data transmission mode is, common is USB, RS232 or RS485, TCP/IP, etc. Pay special attention to the settings; if it is a U disk, then insert the U disk attendance opportunity on the attendance machine to automatically discover the hardware, and then follow the prompts to operate, generally automatically generate the EXCEL form. The specific operation shall be based on the operating instructions of the brand attendance machine. The above is the smart lock China Network Xiaobian finishing the release of the fingerprint attendance machine modification time and export data operation setting method, more relevant methods of use, please refer to this site article! Stud,Blind Standoff,Self Clinching Standoff,Thru-Hole Threaded Standoffs,Nut Standoff Dongguan Tiloo Industrial Co., Ltd , https://www.sales-fastener.com
Fingerprint attendance machine how to change the time fingerprint attendance machine export data operation instructions