Mechanical seals under SEALMANN trademark, adopt the advanced design concepts and the latest achievement of material development and have been proven by large number of successful applications, through the advanced manufacturing technics, testing methods and strict quality assurance system and efficient service support, with the characteristics of high reliability, high stability, long life, and high performance cost ratio. SEALMANN has become the first choice for customers. Seals For Pumps,Sic Mechanical Seal,Mechanical Seal Face,Mechanical Seal For Water Pump Ningbo FLK Technology Co., Ltd. , https://www.flk-global.com
The first use of the water purifier and precautions
[ Pacific Security Network News ]
The first use of the water purifier and precautions
First use: Before the water purifier is used for the first time, it should be washed in strict accordance with the following steps, otherwise it will affect the performance of the water purifier and the quality of the pre-production water.
The water purifier should be flushed before the first use to flush out the protective liquid in the water purifier. The method is as follows:
1. Turn on the tap, tap water inlet ball valve and purifying faucet, and rinse for 15 minutes until the water is clear and free of foam. Frequently switching the taps during the flushing process (off for 3 seconds, open for 10 seconds) causes the water flow to form a pulsating shock, which will make the flushing effect better.
2, close the sewage faucet, open the purification faucet, water can be used normally after 5 minutes.
1. Frequently flushing: In the daily process of using tap water to take water, the water purifier is flushed. It is recommended to open the tap after washing the purified water, and wash away the trapped pollutants in time to keep the water clean. The machine has a higher water flux, which extends the service life.
2. Backwashing to restore water production: If the water production capacity of the water purifier after rinsing is still relatively small, you can consider backwashing the water purifier.
Now, everyone will use it. I want to buy a water purifier at home, so I got to know the precautions from my friends. Finally, tell everyone about some of the precautions that my friends told me. I want to buy a water purifier at home, so I got to know the precautions from my friends.
Note:
1. After the water purifier is used, the ultrafiltration membrane filter should be kept in a wet state. If the ultrafiltration membrane filter is dried, it will cause a sharp drop in water production and cannot be recovered.
2. Do not use the water purifier for more than three days. When using it again, the water purifier should be rinsed repeatedly for 2-5 minutes until the water in the water purifier is drained.
3. In the case of running water in the tap water, please open the sewage faucet and drain the sediment, rust, etc. in the water pipe, and then open the purified faucet to use the purified water.
4. The total water production of the water purifier is related to the influent water quality of the water purifier. If the influent water quality of the water purifier is good, the total water production will increase. If the influent water quality is poor, the total water production will decrease. The filter life will be slightly shorter.
5. When the water purifier is used, the water purifier is often flushed, which can effectively extend the service life of the water purifier.
6, long-term use of water purifier, its water production will gradually decline, but the water quality is still qualified, can be used with confidence.
7. When the water purifier fails, please immediately close the tap water inlet valve and cut off the water inlet of the water purifier. Do not disassemble it by yourself.