Veneer glue is a kind of hand-applied veneer mainly used for convex curved surface, hand-applied wood veneer, profiled veneer, veneer repair and other hand-applied veneer. The real cow hand-applied veneer is a special water-based polyvinyl acetate, one-component, high-solids, fast-drying adhesive. Compared with the universal glue, the glue is environmentally friendly, non-toxic and harmless, with high final strength, solvent resistance and heat resistance. Compared with ordinary white latex, it has less cloth, quick drying and easy operation. High production efficiency and repairability. There are many types of adhesives, among which veneer glue can be divided into hot pressed veneer, cold pressed veneer, vacuum veneer, hand-applied veneer, etc. The cost of the real cow hand-applied veneer in the process is less than 1%. But it plays a vital role. Compared with ordinary white latex, it has high adhesive strength, no foaming, smooth and smooth veneer surface, high efficiency, less uniform coating of rubber coating, softening veneer and so on. Compared with universal glue, it has no paint on the surface. , quick drying, and finally high strength. Veneer is also a special water-based polyvinyl acetate, one-component, high-solids, fast-drying adhesive. Compared with the universal glue, the glue is environmentally friendly, non-toxic and harmless, with high final strength, excellent solvent resistance and heat resistance. Compared with ordinary white latex, it has the advantages of less cloth, quick drying, easy operation, high production efficiency and easy rework (reversible). First, the scope of application It is mainly used for the process of hand-applied veneer, such as hand-applied veneer, profiled veneer, veneer repair, etc. Especially for the curved design of furniture veneer, hand-applied veneer, profiled edge sealing, provides a good method to solve the problem of paint blistering. It will greatly promote the transformation of furniture design. Veneer, decorative paper and other hot and cold pressure veneers, especially suitable for manual veneer edge sealing, veneer and other processes, even if the 0.6mm thick or thicker veneer is not limited, as long as it is convenient to use electric iron heating porous The glue can be used for the material veneer. Second, the method of use 1. Apply double-coated rubber with a short-haired roller. Under the condition of ensuring uniform coating, the amount of glue of 80-100 g/m2 is ideal. 2, the side that is not easy to absorb water first glue (such as MDF veneer, veneer first glue, solid wood veneer, solid wood first glue, etc.), placed at 25 ° C for 1-3 minutes (according to the amount of glue) It is best to touch the hand to feel a little sticky but the glue is not transferred to the hand. 3. Heat with an electric iron (temperature about 150-170 ° C) for 3-5 seconds, the edge of the sheet is heated for a little longer, about 5-10 seconds. After 2 hours of pasting, if it is found that there are air bubbles or not sticking, use iron and then iron it, paint it after 24 hours. 4. If single-sided cloth is used, the veneer will be covered immediately after the glue is applied, and the veneer will be flattened by hand, and then heated and heated (mainly suitable for flat hand fitting). 5. When the site temperature is lower than 13 °C, it will close immediately after the glue is applied. China manufacture Fiberboard screws, Chipboard Screw, cardboard screws, Cheapborad Screw Hebei Kangjin Metal Products CO.,Ltd , https://www.kjmetalproducts.com
Adhesive knowledge - the effect of veneer bonding