bibcock valve,bibcock kitchen taps,bib tap,bibcock valve plastic,brass bibcock valve Yuyao Gaobao Sanitary Ware Factory , https://www.gurberry.com
In life, we call the telephone lines, network cables, cable television lines and audio cables as weak wires. In home decoration, the following points should be noted in the layout of telephone lines, network cables, and cable television lines:
First, centralized control: With the advent of the Internet and information age, it is not uncommon for a family to install two phones or multiple computers to access the Internet. In order to ensure the quality of docking of various lines and facilitate maintenance, it is better to design a centralized control unit for the telephone lines and network lines in the home.
According to the location of the network cable into the room to select the hall, aisle, study room and some other place, design a small box (in the shape of a power distribution box), all the external access to the phone line, network cable, cable TV line When you arrive at the cable box, the telephone jacks, network jacks, and cable jacks in each room of your home must also reach the cable box. You can connect to the online box according to your family's needs.
The second point, to reserve enough jacks for wiring: In consideration of the development and needs of family life, the general living room and each bedroom must reserve 1-2 telephone lines, network cables, and cable TV line jacks. And to be distributed in different walls, in order to change the location of electrical appliances. Bathrooms and kitchens can also consider whether or not to reserve a telephone jack according to need. The restaurant can also consider whether to reserve a pre-advanced TV line jack to prepare for watching TV while dining.
The third point is that weak cables avoid strong wires: weak signals belong to low-voltage signals and have poor anti-interference performance. Therefore, weak wires should be routed away from strong wires (power cables). According to national standards, the horizontal distance between power cords and sockets and TV lines and sockets should not be less than 50 cm.
The fourth point, weak cables pay attention to moisture: the lower edge of the socket is about 30 centimeters from the ground. In general, these weak wires are often laid on the roof or under the floor, so for moisture protection and easy replacement, a solid casing is added to the outside of these wires and the wires are checked for open or short circuits before being applied. .
The four points mentioned above should be noted. If everyone notices in the construction of integrated wiring, then our project can have a good quality assurance.
Talking about the matters needing attention when wiring weak cables
As we all know, the integrated wiring is a relatively complicated and tedious work, so we must be careful and planned in the wiring. With the advancement of science and technology, the improvement of people's living standards and the intelligentization of family life are constantly improving. Therefore, we can hardly ignore the presumption of weaker lines. Let's talk about the precautions when wiring weak cables in the wiring.