Ceramic Pressure Sensor have the characteristics of high
quality, high stability, small size, low weight, compact structure,
low cost and volume-production. It is widely used to measure pressure
such as occasion of compressor, Auto, air-condition etc.
The product is made of stainless steel and well-known brand sensor.
The special transmitter converting circuit can adjust the zero
value and the full range expediently. It also has the intrinsically safe
certificate, the explosion-proof certificate and the CE certificate. Ceramic Pressure Sensor,Ceramic Pressure Transmitter,Ceramic Liquid-Filled Differential Pressure Sensor,Ceramic Pressure Transducer Xi'an Gavin Electronic Technology Co., Ltd , https://www.cngamicos.com
Conveyor belt deviation reason and its treatment method
Reason introduction 
Conveyor belt deviation during belt conveyor operation is one of the most common failures. There are many reasons for deviation, the main reason is the low installation accuracy and poor daily maintenance. During the installation process, the head and tail rollers and the intermediate rollers are as close as possible to the same center line and parallel to each other to ensure that the conveyor belt is not biased or less biased. In addition, the strap joints should be correct and the circumferences on both sides should be the same.
Approach
During the use, if there is a deviation, the following checks should be made to determine the cause and make adjustments. The parts and treatment methods for the conveyor belt to be frequently checked are:
(1) Check the misalignment of the transverse centerline of the idler and the longitudinal centerline of the belt conveyor. If the non-coincidence value exceeds 3 mm, it should be adjusted with the long mounting holes on both sides of the roller set. The specific method is which side of the conveyor belt is biased, which side of the roller set moves forward in the direction in which the conveyor belt advances, or moves backward on the other side.
(2) Check the deviation values ​​of the two planes of the head and tail frame mounting housing. If the deviation between the two planes is greater than 1 mm, the two planes should be adjusted in the same plane. The adjustment method of the head roller is: if the conveyor belt runs away from the right side of the drum, the bearing seat on the right side of the drum should move forward or the left bearing seat moves backward; if the conveyor belt runs away from the left side of the drum, then The bearing housing on the left side of the drum should move forward or the right bearing housing moves back. The tail roller is adjusted in the opposite way to the head roller.
(3) Check the position of the material on the conveyor belt. The material is not centered on the cross section of the conveyor belt and will cause the conveyor belt to run off.
If the material is on the right side, the belt runs to the left and vice versa. The material should be centered as much as possible when in use. To reduce or avoid such conveyor belt deviation, the baffle can be added to change the direction and position of the material.
Five-star program, one-stop solution due to needs - Anping County Yabei Wire Mesh Products Co., Ltd. Welcome to inquire - Anping Yabei 18833272313
Mobile: one eight seven three two seven seven two three one three
QQ: eight four six six two two six one 
Conveyor belt deviation reason and its treatment method