Architectural Model,Building Design Model,Architecture Maquette,Architectural Scale Models Nanjing Great Century Art Model Co., Ltd. , , https://www.dsjysmx.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Characteristics of outer spherical bearings Characteristics of outer spherical bearings
The outer spherical ball bearing is a variant of the deep groove ball bearing in practice; its characteristic is that the outer diameter of the outer ring is spherical; it can be fitted into the corresponding concave spherical surface of the bearing seat to achieve the effect of self-aligning. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Although its fundamental function should be similar to that of deep groove ball bearings; however, most of these bearings are used in relatively rough machines; the positioning of the device is not accurate; the axis of the shaft and the hole is poorly centered; or the axis is long and the deflection is In the case of a large class; and the accuracy of the bearing itself is not high; some layouts are also rough; therefore, the practice of the common function reflects the same standard deep groove ball bearing to be equipped with a suitable buckle. For example, the outer spherical ball with the top wire The bearing is applied to the through shaft with large difference of rigidity and deflection; the bearing has sealing ring on both sides; it can avoid the intrusion of dirt tightly; the excess lubricant is filled when leaving the factory; there is no need to remove the device before the device; no need to add lubricant; bearing The top wire screw on the protruding end of the inner ring is fastened on the shaft. The axial load of the promise shall not exceed 20% of the additional dynamic load.
The outer spherical ball bearing with the partial pain sleeve has the same function as the outer spherical bearing with the top wire; only the top wire is not on the inner ring; instead, it is on the partial pain sleeve. The inner hole of the tapered spherical outer spherical ball bearing is the belt 1: 12-cone tapered bore; can be mounted directly on the tapered shaft; or with a tight bushing on the shaft without the shoulder; fine-tuning the bearing clearance.
Recommend to friends comments close window Bearing related knowledge Bearing layout method to select the "six major problems" of INA bearing demand thinking
How to correctly install low-noise bearing solid smooth bearing brick machine bearing smooth oil classification and application matters needing attention
This article links to http://
Please indicate China Bearing Network http://
Previous: Analysis: Device cooperation and adjustment methods for high-speed bearings Next: Introduction to bearing erosion
Characteristics of outer spherical bearings
Source: Bearing network time: 2014-04-29