Code blank machine operating procedures
(1) Before booting
1 Check if the fastening screws of the code blank machine are tight and the lubrication points are lubricated.
2 Check if the rotating part of the device is flexible and there is no jam.
3 Check whether the gas circuit, lifting chain, solenoid valve, photoelectric tube, proximity switch, etc. are in good condition, and the barometer indicates whether the production required pressure is reached.
4 Check that the console button is in the specified position.
5 Check if the code blank blank is in the correct way.
6 Check if the kiln car bracket brick is clean and flat, and the kiln car is in place.
7 Empty car trial operation, when it is confirmed that everything is normal, it can be turned on.
(2) In the boot
1 When the equipment is running, the safety signal should be used correctly, and the operating status of the equipment should be kept in mind. If the equipment is found to have abnormal noise, stop it immediately to avoid accidents.
2 If the action mode is incorrect or the operation is not in place, the button should be manually adjusted to clear and clear the position in time.
3 Take care to avoid touching the photocell.
4 Adjust the kiln car in time to avoid downtime caused by no car.
5 Observe the billet group conveyed by the billet unit, and divide the seam to make timely adjustment to avoid the clip of the clip and the blank and the blank.
6 It is required that the unqualified blanks should not be coded on the kiln car, and the turned and skewed bricks should be straightened at the fastest speed to avoid affecting the next blank.
3) After shutdown
1 Clean the equipment and hygiene
2 Make a record of the handover
Code blank machine operating procedures