Galvanized Square Pipe,Galvanized Tube,Galvanized Square Tubing,Galvanized Square Tube Shandong Xinsuju Steel Co.,Ltd. , https://www.suscoil.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Bearing device and disassembly Bearing device and disassembly
Clean the bearings and associated parts with clean kerosene or petrol, /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Check whether the bearings that are ready for use can match the original type;
Use a special device to press the bearing into the sleeve; the diameter of the east and west sleeves should not exceed the outer diameter of the bearing ribs; the force should be evenly distributed in the device; do not impact and rough equipment,
After the bearing device is finished, the bearing and associated components should be rotated; check for stuck images and abnormal noise.
Write the specified grease or lubricant as required by the main unit components.
When the large bearing and the bearing between the bearing and the shaft and the seat hole are large, it is necessary to heat the bearing in the oil bath; the oil temperature is about 80 degrees Celsius.
When the bearing is disassembled; it is necessary to use special things for drawing; it is strictly forbidden to directly hit the bearing with iron.
When the bearing device is disassembled, it shall be prevented from being stressed or deformed by the rolling body and the cage.
Recommend to friends comments close window Bearing related knowledge NTN bearing data heat treatment skills
Characteristics and depiction of INA thin-wall bearing products
Analysis of wear failure of NTN imported bearings: bearing common sense: how to "distinguish the authenticity of bearings"
Introduction to Timken Bearing
This article links to http://
Please indicate the bearing network http://
Previous:China's bearing parts heat treatment problems and countermeasures Next: Some basic concepts of bearings
Bearing device and disassembly
Source: China Bearing Network Time: 2018-06-01