kaiping aida sanitary ware technology co.,ltd , https://www.kpfaucets.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Accounting method of bearing life Calculation method of bearing life
Usually; the rolling bearing life cycle accounting process is: /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1. According to the technical parameters of the main engine and the layout of the support part; the type and scale of the primary bearing; the effect of the calculation on the bearing,
2. Calculate the equivalent dynamic load,
About the extra extra life of ball bearings:
L10=(Cr/Pr)3 (million revolutions)
About the extra extra life of roller bearings:
The extra life of rolling bearings refers to the number of running (over 106 revolutions) or the number of working hours at a certain speed of 90% of the bearings in a batch of bearings before they fall off.
Lh=(Cr/Pr)3/(60n)*106 (hours)
The extra life calculation method is based on the usual bearing steel and normal operating conditions; the reliability of the life is 90%. Considering the influence of data and operating conditions and the demand for high reliability; the world standardization arrangement has carried out the extra life formula. Correction; added reliability factor, data coefficient and operating condition coefficient.
Pr: is the radial equivalent dynamic load (KN); refers to the radial mass change load of various applied loads subjected to bearing practice.
At present, the life expectancy of the world's leading ball bearing practice is more than ten times the calculated life; the reliability is more than 95%; the service life of the ball bearing produced by our factory can reach the domestic leading level.
Lh=(Cr/Pr)10/3/(60n)*106 (hours)
3. Calculate the life of the bearing based on the extra life of the bearing formula,
In the meantime, Cr: is the radial extra dynamic load (KN); it refers to a set of rolling bearings that are supposed to accept a stable radial load; the fundamental extra life under this load effect is one million revolutions.
4. Check the additional static load and limit speed.
In practice accounting; usually the number of hours of operation is used to indicate the life of the bearing (hours); is: L10 = (Cr / Pr) 10 / 3 (million revolutions)
Recommend to friends comments close window Bearing related knowledge Koyo bearing correct device and faults look at the rolling mill bearing device before the preparation of the slewing bearing special information four types of skills analysis: motor bearing grease functional requirements ball bearing oscillation and noise analysis
This article links to http://
Please indicate China Bearing Network http://
Previous: SKF bearing alignment error Next: The fundamental selection of bearing scale
Calculation method of bearing life
Source: Bearing network time: 2017-12-28